- YOUR ATLASBIOVIB® HAS ARRIVED
Welcome to relief. Here's how to get it right.
Here’s exactly how to use your AtlasBIOvib®, in three steps and about two minutes. This page walks you through your first session, where the pressure points actually are, and what to do after.
What's in your box
01
The AtlasBIOvib®
Your device, with the green vibrating silicon tip attached (keep it attached).
02
Charging Cable & Wall Adapter
Micro-USB cable and wall adapter for recharging.
03
Printed How-To-Use Guide
A pocket version of everything on this page.
Recharging, when you need it
Your unit arrives fully charged, so there’s nothing to do before your first session. Here’s what to do once it starts running low.
Connect the cable
Plug the charging cable into the port at the base of the handle, then connect the other end to the included wall adapter or any standard USB port.
Know when it's full
A steady green light will confirm the charge is complete.
How to Use the AtlasBIOvib®: The 3-Step Reset
01
POWER
Turn it on and pick your speed
Press and hold the power button until the tip starts vibrating. Tap again to cycle through the three speeds.
- New to it? Start on speed 1 for your first few sessions.
- Move up to speed 2 or 3 once you know how your neck responds.
02
PLACE
Find the base of your skull, not the middle of your neck
Tip your chin down slightly. Run a finger up the back of your neck until you feel the bony ridge where your skull ends, that ridge is your landmark. The suboccipital muscles sit just below it, in the two soft hollows on either side of your spine.
- Rest the silicon tip in one hollow first, not directly on the spine.
- Light contact is enough, you don’t need to press hard to feel it working.
03
PRESS
Hold for 10 to 30 seconds, then move to the other side
Keep light, steady contact and let the vibration do the work, no need to dig in. Breathe normally. When the 30 seconds are up, lift the tool and place it an inch away from that point and begin the 30 seconds again. Repeat until you have reached the other side of the base of your skull.
A feel for how long 10 seconds actually is, before you try it on your neck.
Watch it in Action
Dr. Ashley Twynam, PT, DPT, AtlasPROfilax practitioner explains how to use the AtlasBIOvib®.
Common Questions After Purchase
Some people feel it release in the first minute, others need a few sessions before it's obvious. If your neck tends to hold a lot of tension, be patient and check your placement against the diagram above before assuming it isn't working.
Connect the power cable and adaptor to the tool. Plug it in and let it charge over night.
- A flashing light indicates the tool is charging.
- A steady green light indicates the tool is fully charged.
No, it's designed for self-use only. Using it on someone else isn't within its intended use.
Yes, for most people. One to three minutes a day is typical. If you have a specific medical condition, check with your provider first.
You're covered by a 30-day money-back guarantee and a 1-year limited warranty. Reach out through the contact link below and we'll take care of it.
Have more questions?
Click below and ask us!
How's it working for you?
If it’s already found a place in your routine, a quick review helps the next person deciding whether to trust theirs to it too.
Join the Movement.
Feel the Alignment.











The Legal Stuff
The AtlasBIOvib® is not FDA approved and not classified as a medical device. The AtlasBIOvib® is meant for self-use only and is not meant to be used on others. The AtlasBIOvib® is not intended to diagnose, treat, or prevent any diseases. If you are pregnant or have any medical conditions, please consult your physician before using the AtlasBIOvib®. The AtlasBIOvib® is only intended to be used as instructed in the User Manual. Used beyond its intent is completely the responsibility of the user.





